A. G. Okunev, V. E. Sharonov, A. V. Gubar, I. G. Danilova, E. A. Paukshtis, E. M. Moroz, T. A. Kriger, V. V. Malakhov and Y. I. Aistov, “Sorption of Carbon Dioxide by the Composite Sorbent: Potassium Carbonate in Porous Matrix,” Russian Chemical Bulletin, Vol. 52, No. 2, 2003, pp. 359-363.

has been cited by the following article:

• TITLE: Study on the Effect of Preparation Parameters of K2CO3/Al2O3 Sorbent on CO2 Capture Capacity at Flue Gas Operating Conditions

  AUTHORS: Javad Esmaili, Mohammad Reza Ehsani

  KEYWORDS: CO2 Capture; K2CO3/Al2O3 Sorbent; Response Surface Method; Box-Behnken Design

  JOURNAL NAME: Journal of Encapsulation and Adsorption Sciences, Vol.3 No.2, June 14, 2013

  ABSTRACT: In this paper, study on the effect of preparation conditions of K2CO3/Al2O3 sorbent was done. Box-Behnken design was applied to study the influence of four parameters involve initial solution concentration, impregnation time and calcination step temperature and time. A quadratic model was used to correlate the sorbent capture capacity. The model was used to calculate the optimum conditions for preparing sorbent. From the analysis of variance (ANOVA), the most influential factor on each experimental design response was identified. The potassium-based sorbents used in this study were prepared by impregnating K2CO3 on Al2O3 support. The CO2 capture capacity was measured in the presence of H2O in a fixed-bed reactor at CO2 capture temperature of 60°C using breakthrough curves. The optimum sorbent prepared by this method showed CO2 capture capacity of 77.21 mg CO2/g sorbent. It was observed that the experimental values obtained were in good agreement with the values predicted by the model, with relatively small errors between the predicted and the actual values. The results obtained in this study can be used as basic data for study on design and operating condition optimization of CO2 capture process using these sorbents.