Haque, S., Ansari, A.H. and Bharti, P.K. (2014) Effect of Process Parameters on Wear Rate of Al 6061-Cu reinforced SiCp Metal Matrix Composites. Journal of Material Environmental Sciences, 5, 1485-1489.

has been cited by the following article:

• TITLE: Evaluation of Wear and Corrosion Properties of AA6061/TiB2 Composites Produced by FSP Technique

  AUTHORS: Dakarapu Santha Rao, Nallu Ramanaiah

  KEYWORDS: Friction Stir Processing, TiB2, Metal Matrix Composites, Wear, Corrosion

  JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.5 No.6, October 19, 2017

  ABSTRACT: Aluminum alloys are used frequently in aerospace and ship building industry. Due to poor wear and corrosion resistance, conventional aluminum alloys are replaced by metal matrix composites (MMC). Aluminum alloy matrix reinforced with ceramic particles (TiB2) has importance in industry where components slide each other. The main task is to produce MMCs with low cost effective way to meet the requirement. In this study, an attempt is made to produce AA6061/TiB2 MMCs with different volume fractions of ceramic particles using friction stir processing technique. The dry sliding wear behavior of composites was investigated using pin on disc method. The lowest wear resistance has obtained for 8% composite. The corrosion of composites was analyzed by salt spray method. It was found that wear and corrosion resistance was increased with increase of reinforcement which was higher for 8% composite.