Hossain, S., Deb, U.K. and Rahman, K.A. (2015) The Enhancement of Heat Transfer in a Circular Tube with Insert and without Insert by Using the Finite Element Method. Procedia Engineering, 105, 81-88.
https://doi.org/10.1016/j.proeng.2015.05.010

has been cited by the following article:

• TITLE: Simulation of Heat Transfer in a Tubular Pipe Using Different Twisted Tape Inserts

  AUTHORS: Md. Moniruzzaman Bhuyan, Ujjwal K. Deb, M. Shahriar, Simul Acherjee

  KEYWORDS: Heat Transfer, Non-Isothermal Flow, Tubular Pipe, Twisted Tape Inserts, Simulation

  JOURNAL NAME: Open Journal of Fluid Dynamics, Vol.7 No.3, September 28, 2017

  ABSTRACT: This paper performs a simulation study of the heat transfer phenomena in a tubular U-loop pipe. We have investigated the enhancement of heat transfer with mass flow in a pipe without insert, with full length and short length twisted tape inserts. The length of the pipe is approximately 2436.80 mm long with 29 mm inner and 33 mm outer diameter respectively. A constant heat flux is taken which generated the boundary layer of the pipe close to the flowing fluid around the boundary. The simulations are considered for the stationary and the time dependent module for 35 seconds with different length of inserts. The comparisons are made among the results. We observed that the transfer of heat is enhanced significantly with the increase of the length of inserts inside the computational domain. We also found that, full length twisted tape inserts are more effective than comparing with the short length inserts and without insert.