Turgut, O. and Onur, N. (2009) Three Dimensional Numerical and Experimental Study of Forced Convection Heat Transfer on Solar Collector Surface. International Communications in Heat and Mass Transfer, 36, 274-279.
http://dx.doi.org/10.1016/j.icheatmasstransfer.2008.10.017

has been cited by the following article:

• TITLE: Numerical Investigation of Wind Flow around a Cylindrical Trough Solar Collector

  AUTHORS: Seyyed Mohammad Nima Shojaee, Mohammad Adel Moradian, Mashhood Mashhoodi

  KEYWORDS: Component, Flow Analysis, Wind Forces, Solar Collectors, Cylindrical Trough Collector, Computational, Solar Energy

  JOURNAL NAME: Journal of Power and Energy Engineering, Vol.3 No.1, January 9, 2015

  ABSTRACT: The goal of this study is to model the effects of wind on Cylindrical Trough Collectors (CTCs). Two major areas are discussed in this paper: 1) heat losses due to wind flow over receiver pipe and 2) average forces applied on the collector’s body. To accomplish these goals a 2D modeling of CTC was carried out using commercial codes with various wind velocities and collector orientations. Ambient temperature was assumed to be constant at 300 K and for specific geometries different meshing methods and boundary conditions were used in various runs. Validation was done by comparing the simulation results for a horizontal collector with empirical data. It was observed that maximum force of 509.1 Newton per Meter occurs at +60 degrees. Nusselt number is almost the constant for positive angles while at negative angles it varies considerably with the collector’s orientation.