C. M. Ward-Close, L. Chandrasekaran, J. G. Robertson, S. P. Godfrey and D. P. Murgatroyde, “Advances in the Fabrication of Titanium Metal Matrix Composite,” Materials Science and Engineering A, Vol. 263, No. 2, 1999, pp. 314-318. http://dx.doi.org/10.1016/S0921-5093(98)01162-9

has been cited by the following article:

• TITLE: Prediction of the Elastic Properties of Short Basalt Fiber Reinforced Al Alloy Metal Matrix Composites

  AUTHORS: Ezhil Vannan, Paul Vizhian

  KEYWORDS: Metal Matrix Composites (MMCs); Basalt Fiber; Micromechanical Models; Scanning Electron Microscopy (SEM)

  JOURNAL NAME: Journal of Minerals and Materials Characterization and Engineering, Vol.2 No.1, January 17, 2014

  ABSTRACT: In this paper, a micro-mechanical model is implemented in software for the prediction of local mechanical properties of discontinuous short fiber reinforced composites. The model, based on the Mori and Tanaka method, shear-lag, computational model, Nielsen-Chen model and Miwa’s model is used to predict the elastic behaviour of basalt short fiber reinforced with Al alloy composites. The Al/basalt Metal Matrix Composites (MMCs) contain basalt short fiber from 2.5% to 10% in steps of 2.5 wt.% and are fabricated using squeeze infiltration technique. The effects of fiber length and orientation on elastic properties of Al/basalt MMCs are investigated. A comparison between the experimental data and the theoretical data based on physical models is made, and the significance of the findings is discussed. The results show that as short basalt fiber content was increased from 2.5% to 10% by wt.%, an improvement in Young’s modulus of 13.26% has been observed. Optical microscopy was used to examine the general microstructure and fiber distribution in the composite produced. Scanning Electron Microscopy (SEM) was performed on the fractured surface to understand the failure mechanisms.