Design of Low Power CMOS LNA with Current-Reused and Notch Filter Topology for DS-UWB Application


This paper presents the design of a low power LNA with second stage that uses a notch filter for DS-UWB application. The LNA employs a current reuse structure to reduce the power consumption and an active second order notch filter to produce band rejection in the 5 - 6 GHz frequency band. The input reflection coefficient S11 and output reflection S22 are both less than –10 dB. The maximum power gain S21 is 15 dB while the maximum rejection ratio is over –10 dB at 4.8 GHz. The minimum noise figure is 5 dB. The input referred third-order intercept point (IIP3) is –7 dBm at 6 GHz. The power consumption is 6.4 mW from a 1-V power supply.

Share and Cite:

M. Hsu, J. Du and W. Chiu, "Design of Low Power CMOS LNA with Current-Reused and Notch Filter Topology for DS-UWB Application," Wireless Engineering and Technology, Vol. 3 No. 3, 2012, pp. 167-174. doi: 10.4236/wet.2012.33024.

Conflicts of Interest

The authors declare no conflicts of interest.


[1] S. Stroh, “Ultra-Wideband: Multimidea Unplugged,” IEEE Spectrum, Vol. 40, No. 9, 2003, pp. 23-27. doi:10.1109/MSPEC.2003.1228004
[2] R.-C. Liu, K.-L. Deng and H. Wang, “A 0.6-22-GHz Broadband CMOS Distributed Amplifier,” IEEE Radio 8-10 June 2003, pp. 103-106.
[3] A. Bevilacqua and A. M. Niknejad, “An Ultrawideband CMOS Low-Noise Amplifier for 3.1-10.6-GHz Wireless Receivers,” IEEE Journal of Solid-State Circuits, Vol. 39, No. 12, 2004, pp. 2259-2268. doi:10.1109/JSSC.2004.836338
[4] L. Yang, Y. Kiat Seng, A. Cabuk, M. Jianguo, D. Manh Anh and L. Zhenghao, “A Novel CMOS Low-Noise Amplifier Design for 3.1 to 10.6-GHz Ul-tra-Wide-Band Wireless Receivers,” IEEE Transactions on Circuits and Systems, Vol. 53, No. 8, 2006, pp. 1683-1692. doi:10.1109/TCSI.2006.879059
[5] C.-H. Chen, M. J. Deen, Y. Cheng and M. Matloubian, “Extraction of the Induced Gate Noise, Channel Noise, and Their Correlation in Submicron MOSFETs from RF Noise Measurements,” IEEE Transactions on Electron Devices, Vol. 48, No. 12, 2001, pp. 2884-2892. doi:10.1109/16.974722
[6] B. Razavi, “Design of Analog CMOS Integrated Circuits,” McGraw-Hall, Boston, 2001.
[7] T. H. Lee, “The Design of CMOS Radio-Frequency Integrated Circuit,” 2nd Edition, Cambridge Press, Cambridge, 2004.
[8] A. van der Ziel, “Noise in Solid-State Devices and Circuits,” John Willey and Sons, New York, 1986.
[9] D. K. Shaeffer and T. H. Lee, “A 1.5-V, 1.5-GHz CMOS Low Noise Amplifier,” IEEE Journal of Solid-State, Vol. 32, No. 5, 1997, pp. 745-759. doi:10.1109/4.568846
[10] M.-T. Hsu and K.-J. Li, “An Ultrawideband CMOS Low Noise Amplifier for 3.1-10.6 GHz Wire Less Communication,” ICUWB 2007, Sin-gapore City, 24-26 September 2007, pp. 457-460.
[11] B. Razavi, “RF Microelectronics,” Prentic-Hall, Eglewood Cliffs, 1998.
[12] Y.-J. Lin, S. S. H. Hsu, J.-D. Jin and C. Y. Chan, “A 3.1 - 10.6 GHz Ultra-Wideband CMOS Low Noise Ampli-fier with Current-Reused Technique,” IEEE Microwave and Wireless Components Letters, Vol. 17, No. 3, 2007, pp. 232-234. doi:10.1109/LMWC.2006.890503
[13] Z.-Y. Huang, C.-C. Huang, Y.-T. Hung and M.-P. Chen, “A CMOS Current Reused Low-Noise Amplifier for Ultra-Wideband Wireless Receiver,” International Conference on Microwave and Milli-meter Wave Technology, Chengdu, 19-21 November 2008, pp. 1499-1502. doi:10.1109/ICMMT.2008.4540731
[14] H. L. Kao, A. Chin, K. C. Chang and S. P. McAlister, “A Low-Power Current-Reuse LNA for Ultra-Wideband Wireless Receivers from 3.1 to 10.6 GHz,” Topical Meeting on Solid-State Circuits, Silicon Monolithic Integrated Circuits in RF Systems, Long Beach, 10-12 January 2007.
[15] S. Shekhar, X. Li and D. J. Allstot, “A CMOS 3.1 - 10.6 GHz UWB LNA Employing Stagger-Compensated Series Peaking,” IEEE RFIC Symposium, San Francisco, 11-13 June 2006, pp. 49-52.
[16] C.-P. Liang, P.-Z. Rao, T.-J. Huang and S.-J. Chung, “Analysis and Design of Two Low-Power Ultra-Wide-band CMOS Low-Noise Amplifiers with Out-Band Rejection,” IEEE Transactions on Microwave Theory and Techniques, Vol. 58, No. 2, 2010, pp. 277-286. doi:10.1109/TMTT.2009.2037855
[17] A. Vallese, A. Bevilacqua, C. Sandner, M. Tiebout, A. Gerosa and A., Neviani, “Analysis and Design of an Integrated Notch Filter for the Re-jection of Interference in UWB Systems,” IEEE Journal of Solid-State Circuits, Vol. 44, No. 2, 2009, pp. 331-343. doi:10.1109/JSSC.2008.2010984
[18] T.-K. Nguyen, N.-J. Oh, C.-Y. Cha, Y.-H. Oh, G.-J. Ihm and S.-G. Lee, “Image-Rejection CMOS Low-Noise Amplifier Design Optimiza-tion Techniques,” IEEE Transactions on Microwave Theory and Techniques, Vol. 53, No. 2, 2005, pp. 538-547. doi:10.1109/TMTT.2004.840744
[19] P. Bi and D. Anh, “Dual-Mode Tunable Q-Enhanced Filter for Narrowband and UWB Systems,” Canadian Conference on Electrical and Computer Engineering, Ottawa, 7-10 May 2006, pp. 2318-2321.
[20] A. T. Kenneth, B. Leonid, W. H. James and N. Jonh, “Ultra Wideband Front-End with Tunable Notch Filter,” IEEE North-East Workshop on Circuits and Systems, Gatineau, 18-21 June 2006, pp. 177-180.
[21] R.-M. Weng, R.-C. Kuo and P.-C. Lin, “An Ultra-Wideband LNA with Notch Filter,” 17th International Conference Radioelektronika, Brno, 24-25 April 2007. doi:10.1109/RADIOELEK.2007.371431
[22] C.-C. Huang, Z.-Y. Huang, Y.-C. Wang, Y.-T. Huan and M.-P, Chen, “0.18 μm CMOS Low-Noise Amplifier with 2nd-Order Notch Filter for Ultra-Wideband Wireless Receiver,” IEEE International Workshop on Radio-Frequency Integrated Technology, Singapore City, 9-11 December 2007.
[23] J. Asmussen, S. P. Sah, X. M. Yu and D. Heo, “A Wideband Body Biased Low-Noise Amplifier,” International Conference on Green Circuits and Systems, Shanghai, 21-23 June 2010, pp.687-690.

Copyright © 2024 by authors and Scientific Research Publishing Inc.

Creative Commons License

This work and the related PDF file are licensed under a Creative Commons Attribution 4.0 International License.