Study on Calculation Method for Partition of Heat Transfer in an Ultra-supercritical Boiler

Abstract

Use a 1000MW ultra-supercritical tower boiler as the research object. On the basis of one dimensional model, simplify the tube heat transfer model and the radiation heat transfer model; establish the two-dimensional area calculation model with the regional method; summarize the heat load distribution of flue gas temperature and water wall surface; and compare with the measured data. The error range of the result is acceptable on the project. The distribution of water wall surface heat load along the furnace width and the area where heat transfer deterioration cause easily along the furnace height direction are studied with the model and algorithm on different boiler load conditions. All these provide the reference for the design and operation of the ultra supercritical boiler.

Share and Cite:

Y. Teng, Z. Zhang, X. Liu, W. Liu, T. Zhou and M. Zhu, "Study on Calculation Method for Partition of Heat Transfer in an Ultra-supercritical Boiler," Energy and Power Engineering, Vol. 5 No. 4B, 2013, pp. 311-314. doi: 10.4236/epe.2013.54B061.

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1] J. F. Yue , S. H. Liang, X. Y. Ning, et al., “Structural Features and Performance Analysis of Wall-arrangement Tangential Firing System for a 600 MW Ultra Supercritical Boiler,” Journal of Chinese Society of Power Engineering, Vol. 31, No. 8, 2011, pp. 598-604.
[2] M. Zhu, Z. X. Zhang, T. Zhou, et al., “Calculation on Water Wall Temperature in the Furnace of a 1000 MW Ultra-supercritical Tower Boiler,” Journal of Chinese Society of Power Engineering, Vol. 32, No. 1, 1995, pp. 1-8.
[3] M. Yu, G. Y. Yu, F. X. Zhang, et al., “Heat Transfer Characteristics of Vertical Upward Internally Ribbed Tube in Supercritical Sliding-pressure Operation Boilers,” Journal of Chinese Society of Power Engineering, Vol. 31, No. 5, 2011, pp. 321-324.
[4] T. Zhou, Z. X. Zhang, C. Zhao, et al., “Simplified Calculation on One-dimensional Combustion and Heat Transfer in 1000 MW USC Tower Type Boilers,” Combustion Science Conference of Chinese society of Engineering Thermophysics, Guangzhou, 3-6 December 2010.
[5] F. G. Liu, “Coupled Convection and Radiation Modeling of Furnace in Supercritical Pressure Boilers Based on Thermal Load Characteristics,” Journal of Combustion Science and Technology, Vol. 16, No. 4, 2010, pp. 369-374.
[6] X. H. Han, Z. R. Zhao and M. C. Zhang, “Mathematical Modelling for Heat Transfer Process in Tangential-fired Boiler Furnace,” Journal of Combustion Science and Technology, Vol. 2, No. 3, 1999, pp. 369-374.
[7] V. B. Ivanovic, “Reliable Simple Zonal Method of the Furnace Thermal Calculation,” Thermal Science, Vol. 9, No. 2, 2005, pp. 45-55. doi:10.2298/TSCI0502045I
[8] Y. Yang, “Experimental Research on the Dynamic and Heat Transfer Characteristics of 1000 MW USC Pressure Once-through Boiler Spiral Water-wall,” Master Dissertation Thesis, Shanghai Power Equipment Research Institute, Shanghai, 2010.

Copyright © 2024 by authors and Scientific Research Publishing Inc.

Creative Commons License

This work and the related PDF file are licensed under a Creative Commons Attribution 4.0 International License.