"A Review on Detonation Gun Sprayed Coatings"
written by Lakhwinder Singh, Vikas Chawla, J.S. Grewal,
published by Journal of Minerals and Materials Characterization and Engineering, Vol.11 No.3, 2012
has been cited by the following article(s):
  • Google Scholar
  • CrossRef
[1] CHARACTERIZATION OF STAINLESS STEEL 316L COATED BY THERMAL SPRAY COATING
International Journal of Advance Research , Ideas and Innovations in Technology.
[2] Dry sliding wear behaviors of Fe-based amorphous metallic coating synthesized by d-gun spray
2020
[3] Influence of Heat Treatment on the Phase Composition and Microhardness of Coatings Based on Ti3SiC2/TiC
2020
[4] DEPOSITION AND PROPERTIES OF CHROMIUM OXIDE BASED COATINGS BY PLASMA SPRAY PROCESS
2020
[5] Comparison of microstructure and oxidation behavior of CoNiCrAlY coatings produced by APS, SSAPS, D-gun, HVOF and CGDS techniques
2020
[6] To Enhance Wear Resistance of Cast Iron Using Thermal Spray Coating Techniques
2020
[7] Characterization and Wear Behaviour of WC-Co Coated Copper under Dry Sliding Conditions.
2020
[8] Microstructure of HVOF-sprayed Ag–BaF2⋅ CaF2–Cr3C2–NiCr coating and its tribological behavior in a wide temperature range (25° C to 800° C)
2020
[9] Investigation of the adhesion properties of calcium-phosphate coating to titanium substrate with regards to the parameters of high-frequency magnetron …
2020
[10] Erosion performance of detonation gun deposited WC–12Co, Stellite 6 and Stellite 21 coatings on SAE213-T12 steel
2020
[11] Manufacturing of wear resistant clads for slurry/tailings pump impellers via laser cladding (lc).
2019
[12] Detonasyon tabancası (d-gun) ve sürep sonik plazma sprey (saps) kaplama yöntemleri ile üretilen mcraly içeriğine sahip kaplamaların mikroyapısal ve mekanik …
2019
[13] Technological challenges for the design of the RFX-mod2 experiment
2019
[14] Investigation on the Erosion Behavior of Coated Piston in the Hydraulic Actuators
2019
[15] Study Of Cyclic High Temperature Hot-Corrosion Behaviour of Bare And Ni-Cr Coating Over Mild Steel
Intl. J. Engg. Sci. Adv. Research, 2019
[16] Ceramics coating materials for corrosion control of crude oil distillation column: Experimental and theoretical studies
2019
[17] Experimental Evaluation of High Temperature Corrosion Performance of 75Ni25Cr Coated and Bare 347H SS in Air and Simulated Husk Fired Boiler Environment
2019
[18] Analysis of D-gun sprayed coating on medium carbon steel
2019
[19] Improving the hot corrosion resistance of boiler tube steels by detonation gun sprayed coatings in actual boiler of thermal power plant
2019
[20] The Effect of Hot Treatment on Composition and Microstructure of HVOF Iron Aluminide Coatings in Na2SO4 Molten Salts
2019
[21] Microstructure and mechanical properties of D-Gun sprayed Cr3C2-NiCr coating on P91 steel subjected to long term thermal exposure at 650° C
2019
[22] Investigation of high temperature corrosion resistance of Ni25Cr coated and bare 347H SS in actual husk fired boiler atmosphere
2019
[23] Interface failure behavior of yttria stabilized zirconia (YSZ), La2Zr2O7, Gd2Zr2O7, YSZ/La2Zr2O7 and YSZ/Gd2Zr2O7 thermal barrier coatings (TBCs) in thermal cyclic …
2019
[24] Computer-Controlled Detonation Spraying: Flexible Control of the Coating Chemistry and Microstructure
2019
[25] Wear Behavior of Boron Steel Coated Cerium Oxide Tungsten Carbide Cobalt Coating
2018
[26] Metallization of Aln Ceramic with Ti Using Detonation Spraying Process–Thermodynamic Approach
2018
[27] Characterization of the Cr
2018
[28] Investigation on microstructural and mechanical properties of HVOF sprayed Inconel-718 coatings on grey cast iron
2018
[29] Effect of coating thickness on microstructure and low temperature cyclic thermal fatigue behavior of thermal barrier coating (Al2O3)
IOP Conference Series: Materials Science and Engineering, 2018
[30] Investigation of Wear Resistant Coatings Deposited on High Chromium Iron Applicable in Hot Rolling
International Journal of Management, Technology And Engineering, 2018
[31] Structure and properties of detonation gun sprayed coatings from the synthesized FeAlSi/Al2O3 powder
Surface and Coatings Technology, 2018
[32] Characterization of the Cr3C2–NiAl coatings on sintered duplex stainless steels
In?ynieria Materia?owa, 2018
[33] An overview of problems and solutions for components subjected to fireside of boilers
International Journal of Industrial Chemistry, 2017
[34] Mechanical and Tribological Properties of Cr3C2-NiCr Coated Ti6Al4V Implant Alloy
2017
[35] Characterizations of plasma sprayed composite coatings over 1020 mild steel
Journal of Mechanical Science and Technology, 2017
[36] Взаємодія кислих фосфатів кальцію з СаО (СаСО₃) при їх нанесенні на поверхню титану в умовах газодетонаційного осадження
2017
[37] Experimental Investigation on Ceramic Surface Coatings on Aluminum using Detonation Gun
2017
[38] Effect of D-Gun sprayed Ceramic Coatings on Aluminum Material to Review Hardness and Corrosion Properties
2017
[39] Wear Between Ring and Traveler: A Pin-On-Disc Mapping of Various Detonation Gun Sprayed Coatings
Materials Today: Proceedings, 2017
[40] The erosion performance of particle reinforced metal matrix composite coatings produced by co-deposition cold gas dynamic spraying
Applied Surface Science, 2017
[41] Evaluation of Thermal Spray Alumina Coatings on Nickel Electrode Connector for Reprocessing Applications
Transactions of the Indian Institute of Metals, 2017
[42] Взаємодія кислих фосфатів кальцію з СаО (СаСО3) при їх нанесенні на поверхню титану в умовах газодеонаційного осадження
2017
[43] The erosion performance of cold spray deposited metal matrix composite coatings with subsequent friction stir processing
Applied Surface Science, 2017
[44] COMBATING HOT CORROSION OF BOILER TUBES WITH DETONATION GUN SPRAYED COATINGS: A REVIEW
2017
[45] Detonation spraying of copper: theoretical analysis and experimental studies
Materials Today: Proceedings, 2017
[46] Role of Thermal Spray Coatings on Wear, Erosion and Corrosion Behavior: A Review
2017
[47] To Study the Corrosion Behavior of D-Gun Sprayed NiCr Coated 347H Stainless Steel under Simulated and Actual Biofuel Fired Boiler Environment
2017
[48] DRY SLIDING WEAR BEHAVIOR OF CR3C2-NICR COATED TI6AL4V IMPLANT ALLOY THROUGH DETONATION SPRAY METHOD
International Journal of Mechanical Engineering and Technology, 2016
[49] Cold gas dynamic spraying of metal matrix composite coatings with subsequent friction stir processing
2016
[50] 爆炸喷涂 Cr3C2-NiCr 涂层的激光重熔工艺
2016
[51] Some Studies on D-Gun Sprayed ASTM SAE213 T22 Steel for High Temperature Applications
2016
[52] ADVANCED CERAMIC COATINGS ON STAINLESS STEEL: A REVIEW OF RESEARCH, METHODS, MATERIALS, APPLICATIONS AND OPPORTUNITIES
2016
[53] Microstructure and Characterization of Detonation Gun Sprayed Al2O3 Coating
2016
[54] Patent Trends of Detonation Spray Coating Technology
Recent Patents on Mechanical Engineering, 2016
[55] Porous biomorphic silicon carbide ceramics coated with hydroxyapatite as prospective materials for bone implants
Materials Science and Engineering: C, 2016
[56] Enhancing the properties of WC/Co detonation coatings using two-component fuels
Surface and Coatings Technology, 2016
[57] Unstructured finite element modeling thermally sprayed cermet coatings post-treatment by pulsed high-energy fluxes
Composite Structures, 2016
[58] 爆炸喷涂 Cr_3C_2-NiCr 涂层的激光重熔工艺
金属热处理, 2016
[59] Characterization of stainless steel 316 l coated by thermal spray coating
2016
[60] Soft magnetic properties of nanocrystalline Fe73B7Si16Nb3Cu1 alloy after rapid heating under tensile stress
Nanoscale Research Letters, 2015
[61] 爆炸喷涂工艺研究进展
热处理, 2015
[62] Technology of Coating Deposition
Bioceramic Coatings for Medical Implants, 2015
[63] A Review on Thermal Spray Coating
International Journal of Scientific & Engineering Research, 2015
[64] Structure of Biocompatible Coatings Produced from Hydroxyapatite Nanoparticles by Detonation Spraying
Nanoscale research letters, 2015
[65] Corrosion Behavior of Bare, Cr3C2-25%(NiCr), and Cr3C2-25%(NiCr)+ 0.4% CeO2-Coated Superni 600 Under Molten Salt at 900° C
Journal of Materials Engineering and Performance, 2014
[66] TO INVESTIGATE THE SLURRY EROSION WEAR BEHAVIOUR OF CENTRIFUGAL PUMP SLEEVE SS-316 WITH THE HELP OF WC-12CO COATING
International Journal of Information Technology & Computer Sciences Perspectives, 2014
[67] Modeling of surface coating deposition by detonation gun spray
D Nélias - www-csc.utt.fr, 2014
[68] Minimum tube diameters for steady propagation of gaseous detonations
Shock Waves, 2014
[69] Wear Behavior of Grey Cast Iron Coated with Al2O3-13TiO2 and Ni20Cr Using Detonation Spray Process
WASET, 2014
[70] Corrosion Behavior of Bare, Cr3C2-25%(NiCr), and Cr3C2-25%(NiCr)+0.4%CeO2-Coated Superni 600 Under Molten Salt at 900 °C
Journal of Materials Engineering and Performance, 2014
[71] Recent advancements in Thermal Spray Coatings
International Journal of Research in Mechanical Engineering & Technology, 2013
[72] Plasma electrolytic oxidation coatings on lightweight metals
2013
[73] Effects of Tribological Parameters on Slurry Erosion Behaviour of Uncoated and Coated Materials: A Review
Materials Engineering-Materiálové in?inierstvo (MEMI), 2013
[74] Studium vlastností kovových materiálů připravených technologií nízkoteplotního kinetického naprašování
2013
[75] СВОЙСТВА ПОКРЫТИЙ, ПОЛУЧАЕМЫХ ДЕТОНАЦИОННЫМ НАПЫЛЕНИЕМ (Обзор)
АА Штерцер, ВЮ Ульяницкий - conf.nsc.ru, 2012
[76] Role of Detonation-Gun spray Coating on Super alloys
[77] The Corrosion Resistance Mechanism of Fe-Based Amorphous Coatings Synthesised by Detonation Gun Spraying
[78] Impact of Carbon Nanotubes Reinforcement on Microstructural and Tribological Characteristics of Air Plasma Sprayed Conventional Alumina-Titania (Al2O3-3wt …
[79] Tribology in Industry