Author(s)

S. Kolsi, H. Samet, M. Ben Amar

Department of Electronics, Sfax High Institute of Electronics and Communications, University of Sfax, Sfax, Tunisia.
Department of Physics, Science Faculty of Sfax, University of Sfax, Sfax, Tunisia.
Electronic Laboratory and Information Technology, Department of Electrical Engineering, Sfax National School of Engineers, University of Sfax, Sfax, Tunisia.

The DC-DC converters are widely used in photovoltaic generating systems as an interface between PV module and the load. These converters must be chosen to be able to match the maximum power point (MPP) of PV module when climatic conditions change with different resistive load values. So DC-DC converters must be used with MPPT controller in order to reduce losses in the global PV system. This article focuses on the effect of climatic conditions on design of two components (inductance, capacitance) for three topologies of DC-DC converters commonly used in PV systems. When climatic conditions change, the boundary of inductance and capacitance parameters of DC-DC converter will change. These two parameters must be properly sized to achieve optimal efficiency for each converter. The design optimization is based on two principles: 1) for a steady-state operation in a continuous conduction mode, the inductance value for all choppers must be greater than the maximum value of boundary inductance, and 2) in order to limit the output voltage ripple of DC-DC converter below a desired value, the filter capacitance must be larger than the maximum value of boundary capacitance.

DC-DC Converter; Energy Efficiency; Design; Load Matching; MPPT

Kolsi, S. , Samet, H. and Amar, M. (2014) Design Analysis of DC-DC Converters Connected to a Photovoltaic Generator and Controlled by MPPT for Optimal Energy Transfer throughout a Clear Day. Journal of Power and Energy Engineering, 2, 27-34. doi: 10.4236/jpee.2014.21004.