Author(s)

Sh. El Yamny, M. Abdel Rafea

Electronic Materials Dep., Advanced Technologies and New Materials Institute, City for Scientific Research and technological Applications 21934, Alexandria, Egypt.

Transparent conducting oxide (TCO) based on indium doped zinc oxide films in the nano scale were successfully prepared using combination between dip coating and thermal decomposition process. Structural investigations confirm the polycrystalline ZnO hexagonal wurtzite phase grown along the c-axis with nano crystallite size about 10 nm. Morphology investigation shows that ZnO films consist of fine grains of average size 40 nm. This indicates that each grain contains several crystallites with different orientations. Cross sectional image presents good adhesion of the films with the substrate and the film thickness has been determined. Compositional analysis detects the indium content in the host ZnO matrix, the In/Zn ratio is close to the calculated concentration ratios of the precursor. The optical transmittance shows that the films are transparent in the UV and VIS-IR spectral region and interference fringes were observed to be thickness dependent. Preparation parameters were investigated and optimized such as dipping rate, number of deposition cycles, precursor concentration, annealing process and In/Zn ratio. Optimization process was investigated for low resistivity, high optical spectral window transmission and easy preparation process. Dipping rate in the range 2 - 38 mm/s is the most suitable range for good film quality while dipping rate range 30 - 38 mm/s produces thicker films in lower deposition cycles. The higher dipping rate produces films with lower transparency (milky films) while the small deposition rate rate requires large number of deposition cycles in order to increase the thickness. Besides, the higher dipping rate reflects lower resistivity of the deposited films. Precursor molar concentration was observed to have an essential effect on the film thickness, film quality and transparency. Lower precursor concentration requires also large number of deposition cycles for thickening the films. The higher concentration results also milky films (high scattering process by powder film). Precursor concentrations in the range 0.7 - 0.9 mol/liter were found to be the optimal for better quality and for faster deposition process. The resistivity of the films has been reduced from the range 1.5 - 2.5 kW?cm to the range 100 - 400 W.cm as the molar concentration reaches the range 0.07 - 0.09 mol/liter. The resistivity of films increases from 330 to 1686 .cm as the decomposition temperature increases from 200C to 350C. Annealing at 450C process after completing the decomposition at 200?C results the lowest resistivity with annealing time in the range 1.5 - 2 h. In/Zn percentage in the range 1.5% - 5% produces the lowest electrical resistivity. The absorption edge of the deposited films was observed to be critical affected by the preparation parameters. The band gap change was discussed through the degenerate semiconductors as well as nanostructured semiconducting materials of the energy gap confinement effect. Deposition of TCO based on ZnO:In was optimized depending on all deposition parameters forwide area, the lower cost and good performance TCO films.

ZnO:In; TCO; Dip Coating; Optical and Electrical Properties

S. Yamny and M. Rafea, "Preparation and Characterization of ZnO: In Transparent Conductor by Low Cost Dip Coating Technique," Journal of Modern Physics, Vol. 3 No. 9, 2012, pp. 1060-1069. doi: 10.4236/jmp.2012.39140.