[1]
|
T.-R. Ling, Z.-B. Chen and M.-D. Lee, “Studies on Catalytic and Conductive Properties of LaNiO3 for Oxidation of C2H5OH3CHO and CH4,” Catalysis Today, Vol. 26, No. 1, 1995, pp. 79-86.
|
[2]
|
T. Hirohisa and M. Makoto, “Advances in Designing Perovskite Catalysts,” Current Opinion in Solid State and Materials Science, Vol. 5, No. 5, 2001, pp. 381-387.
|
[3]
|
S. Liu, K. Li and R. Hughes, “Preparation of SrCe0.95 Yb0.05O3−α Perovskite for Use as a Membrane Material in Hollow Fibre Fabrication,” Materials Research Bulletin, Vol. 39, No. 1, 2004, pp. 119-133.
|
[4]
|
A. M. G. Pedrosa, J. D. G. Fernandes, D. M. Melo, A. S. Araújo, M. J. B. Souza and D. K. Gomes, “Synthesis and Catalytic Properties of Lanthanum Nickelate Perovskite Materials,” Reaction Kinetics and Catalysis Letters, Vol. 84, No. 1, 2005, pp. 3-9.
|
[5]
|
E. Campagnoli, A. Tavares, L. Fabbrini, I. Rossetti, Y. A. Dubitsky, A. Zaopo and L. Forni, “Effect of Preparation Method on Activity and Stability of LaMnO3 and LaCoO3 Catalysts for the Flameless Combustion of Methane,” Applied Catalysis B: Environmental, Vol. 55, No. 2, 2005, pp. 133-139.
|
[6]
|
S. Liu, X. Tan, K. Li, R. Hughes, “Synthesis of Strontium Cerates-Based Perovskite Ceramics via Water-Soluble Complex Precursor Routes,” Ceramics International, Vol. 28, No. 3, 2002, pp. 327-335.
|
[7]
|
A. A. Leontiou, A. K. Ladavos and P. J. Pomonis, “Catalytic NO Reduction with CO on La1−xSrx (Fe3+/Fe4+) O3±δ Perovskite-Type Mixed Oxides (x = 0.00, 0.15, 0.30, 0.40, 0.60, 0.70, 0.80, and 0.90),” Applied Catalysis A: General, Vol. 241, No. 1-2, 2003, pp. 133-141.
|
[8]
|
H. Tanaka and M. Misono, “Advances in Designing Perovskite Catalysts,” Current Opinion in Solid State and Materials Science, Vol. 5, No. 5, 2001, pp. 381-387.
|
[9]
|
N. Yamazoe and Y. Teraoka, “Oxidation Catalysis of Perovskites: Relationships to Bulk Structure and Composition (Valency, Defect, etc.),” Catalysis Today, Vol. 8, No. 2-3, 1990, pp. 175-199.
|
[10]
|
K. Kleveland, M. A. Einarsrud and T. Grande, “Sintering of LaCoO3 Based Ceramics,” Journal of European Ceramic Society, Vol. 20, No. 2, 2000, pp. 185-193.
|
[11]
|
D. Klvana, J. Vaillancourt, J. Kirchnerova and J. Chaouki, “Combustion of Methane over La0.66Sr0.34Ni0.3Co0.7O3 and La0.4Sr0.6Fe0.4Co0.6O3 Prepared by Freeze-Drying,” Applied Catalysis A: General, Vol. 109, No. 2-3, 1994, pp. 181-193.
|
[12]
|
N. Gunasekaran, S. Saddawi and J. J. Carberry, “Effect of Surface Area on the Oxidation of Methane over Solid Oxide Solution Catalyst La0.8Sr0.2MnO3,” Journal of Catalysis, Vol. 159, No. 1, 1996, pp. 107-111.
|
[13]
|
M. Alifanti, R. Auer, J. Kirchnerova, F. Thyrion, P. Grange and B. Delmona, “Activity in Methane Combustion and Sensitivity to Sulfur Poisoning of La1−xCexMn1−yCoyO3 Perovskite Oxides,” Applied Catalysis B: Environmental, Vol. 41, No. 1-2, 2003, pp. 71-81.
|
[14]
|
T. Nitadori and M. Misono, “Catalytic Properties of La1−xA′xFeO3 (A′ = Sr,Ce) and La1−xCexCoO3,” Journal of Catalysis, Vol. 93, No. 2, 1985, pp. 459-466.
|
[15]
|
A. K. Azada, S.-G. Eriksson, S. A. Ivanov, R. Mathieu, P. Svedlindh, J. Eriksen and H. Rundlöf, “Synthesis, Structural and Magnetic Characterisation of the Double Perovskite A2MnMoO6 (A=Ba, Sr),” Journal of Alloys and Compounds, Vol. 364, No. 1-2, 2004, pp. 77-82.
|
[16]
|
F.-C. Buciuman, F. Patcas, J.-C. Menezo, J. Barbier, T. Hahn and H.-G. Lintz, “Catalytic Properties of La0.8A0.2MnO3 (A = Sr, Ba, K, Cs) and LaMn0.8B0.2O3 (B = Ni, Zn, Cu) Perovskites: 1. Oxidation of Hydrogen and Propene,” Applied Catalysis Bi Environmental, Vol. 35, No. 3, 2002, pp. 175-183.
|
[17]
|
R. Spinicci, A. Tofanari, M. Faticanti, I. Pettiti and P. Porta, “Hexane Total Oxidation on LaMO3 (M = Mn, Co, Fe) Perovskite-Type Oxides,” Journal of Molecular Catalysis A: Chemical, Vol. 176, No. 1-2, 2001, pp. 247- 252.
|
[18]
|
G. Saracco, F. Geobaldo and G. Baldi, “Methane Combustion on Mg-Doped LaMnO3 Perovskite Catalysts,” Applied Catalysis B: Envirnomental, Vol. 20, No. 4, 1999, pp. 277-288.
|
[19]
|
R. Zenati, C. Bernard, C. Calmet, S. Guillemet, G. Fantozzi and B. Durand, “Internal Friction Investigation of Phase Transformation in nearly Stoichiometric LaMnO3+δ,” Journal of the European Ceramic Society, Vol. 25, No. 6, 2005, pp. 935-941.
|
[20]
|
M. D. S. Kumar, T. M. Srinivasan, P. Ramasamy and C. Subramanian, “Synthesis of Lanthanum Aluminate by a Citrate-Combustion Route,” Materials Letters, Vol. 25, No. 3-4, 1995, pp. 171-174
|
[21]
|
L. Hong, F. Guo and J. Lin, “From Chelating Precursors to La0.05Sr0.95CoO3−y Oxide,” Materials Research Bulletin, Vol. 34, No. 12-13, 1999, pp. 1943-1958.
|
[22]
|
A. M. G. Pedrosa, M. J. B. Souza, B. A. Marinkovic, D. M. A. Melo and A. S. Araujo, “Structure and Properties of Bifunctional Catalysts Based on Zirconia Modified by Tungsten Oxide Obtained by Polymeric Precursor Method,” Applied Catalysis A: General, Vol. 342, No. 1-2, 2008, pp. 56-62.
|
[23]
|
A. M. G. Pedrosa, D. M. A. Melo, M. J. B. Souza, A. O. S. Silva and A. S. Araujo, “Effect of Cerium, Holmium and Samarium Ions on the Thermal and Structural Properties of the HZSM-12 Zeolite,” Journal of Thermal Analysis and Calorimetry, Vol. 84, No. 2, 2006, pp. 503-509.
|
[24]
|
D. Zhou, G. Huang, X. Chen, J. Xu and S. Gong, “Synthesis of LaAlO3 via Ethylenediaminetetraacetic Acid Precursor,” Materials Chemistry and Physics, Vol. 84, No. 1, 2004, pp. 33-36.
|
[25]
|
Y. H. Huang, Z.-G. Xu, C.-H. Yan, Z.-M. Wang, T. Zu, C.-S. Liao, S. Gao and G.-X. Xu, “Soft Chemical Synthesis and Transport Properties of La0.7Sr0.3MnO3 Granular Perovskites,” Solid State Communications, Vol. 114, No. 1, 2000, pp. 43-47.
|
[26]
|
M. Popa and M. Kakihana, “Synthesis of Lanthanum Cobaltite (LaCoO3) by the Polymerizable Complex Route,” Solid State Ionics, Vol. 151, No. 1-4, 2002, pp. 251-257.
|
[27]
|
S. Nakayama, M. Okazaki, Y. L. Aung and M. Sakamoto, “Preparations of Perovskite-Type Oxides LaCoO3 from Three Different Methods and their Evaluation by Homogeneity, Sinterability and Conductivity,” Solid State Ionics, Vol. 158, No. 1-2, 2003, pp. 133-139.
|