Kouam, J., Ait-Ahcene, T., Plaiasu, A.G., Abrudeanu, M., Motoc, A., Beche, E. and Monty, C. (2008) Characterization and properties of ZnO based nanopowders prepared by solar physical vapor deposition (SPVD). Journal of Solar Energy, 82, 226-238.
http://dx.doi.org/10.1016/j.solener.2007.07.008

has been cited by the following article:

• TITLE: Experimental investigation on PM2.5 particle emission during polishing of granite

  AUTHORS: Jules Kouam, Victor Songmene, Ali Balhoul

  KEYWORDS: Granite; Polishing; PM2.5; Particle Emission; Air Pollution

  JOURNAL NAME: Health, Vol.5 No.10B, October 29, 2013

  ABSTRACT: Particle emission during manufacturing processes, whether chemical, physical or mechanical can represent a serious danger for environment and for occupational safety. Especially machining processes, particle emission could have an important impact on shop floor air quality and might jeopardise workers’ health. It is therefore important to find ways of reducing the particle emission at the source of manufacturing processes. To do so, there is a need to know the size, the quantity and the distribution of particles produced by processes currently used in industry. In this study, investigations are done to compare the particle emission (PM2.5) when polishing two granites (black and white). The black granite contained low Si concentration (about 10% Si) and the white granite contained high Si concentration (about 50% Si). Particle emission was monitored using the DustTrak II equipment with 2.5 μm impactor. The particle grain size was evaluated using X-ray diffraction techniques. Machining conditions leading to the generation of finer particles were identified.