W. Sokól and W. Korpal, “Aerobic Treatment of Wastewaters in the Inverse Fluidised Bed Biofilm Reactor,” Chemical Engineering Journal, Vol. 118, No. 3, 2006, pp. 199-205. doi:10.1016/j.cej.2005.11.013

has been cited by the following article:

• TITLE: Evaluation of the Inverse Fluidized Bed Biological Reactor for Treating High-Strength Industrial Wastewaters

  AUTHORS: Włodzimierz Sokół, Belay Woldeyes

  KEYWORDS: Biological Wastewater Treatment, Aerobic Wastewater Treatment, High-Strength Industrial Wastewaters, Inverse Biological Reactor, Fluidized Bed Bioreactor, Low-Density Biomass Support

  JOURNAL NAME: Advances in Chemical Engineering and Science, Vol.1 No.4, October 26, 2011

  ABSTRACT: The aim of this work was to investigate the aerobic degradation of high-strength industrial (refinery) wastewaters in the inverse fluidized bed biological reactor, in which polypropylene particles of density 910 kg/m3 were fluidized by an upward flow of gas through a bed. Measurements of chemical oxygen demand (COD) versus residence time t were performed for various ratios of settled bed volume to reactor volume (Vb/VR) and air velocities u. The largest COD reduction, namely, from 54,840 to 2,190 mg/l, i.e. a 96% COD decrease, was achieved when the reactor was operated at the ratio (Vb/VR) = 0.55, air velocity u = 0.046 m/s and t = 65 h. Thus, these values of (Vb/VR), u and t can be considered as the optimal operating parameters for a reactor when used in treatment of high-strength refinery wastewaters. In the treatment operation conducted in a reactor optimally controlled at (Vb/VR) = 0.55, u = 0.046 m/s and t = 65 h, the conversions obtained for all phenolic constituents of the wastewater were larger than 95%. The conversions of about 90% were attained for other hydrocarbons.