Withdraw: Improvement on Adhesion Properties of Insert Injection Molding Composites: Effect of Inserted Parts, Adhesive Lengths and Injection Conditions

Badin Pinpathomrat, Hiroyuki Hamada

Department of advanced Fibro-Science, Kyoto Institute of Technology, Kyoto, Japan.

DOI: 10.4236/ojcm.2017.74013                

Abstract

Short Retraction Notice

The paper does not meet the standards of "Open Journal of Composite Materials".

This article has been retracted to straighten the academic record. In making this decision the Editorial Board follows COPE's Retraction Guidelines. The aim is to promote the circulation of scientific research by offering an ideal research publication platform with due consideration of internationally accepted standards on publication ethics. The Editorial Board would like to extend its sincere apologies for any inconvenience this retraction may have caused.

Editor guiding this retraction: Prof. Chengye Fan (EiC of OJCM)

The full retraction notice in PDF is preceding the original paper, which is marked "Withdraw".

Keywords

Insert-Injection Molding, Adhesive Length, Adhesive Normal/Shear Load, Injection Molding Condition, Polypropylene Glass Fiber Composite

Conflicts of Interest

The authors declare no conflicts of interest.

References

[1]	Yoshio, N. and Robert, D. (2000) Handbook of Semiconductor Manufacturing Technology. Marcel Dekker, New York.
[2]	Ryosuke, M., Motoko, S. and Akira T. (2008) Improving Performance of GFRP/Aluminum Single Lap Joint Using Bolted/Co-Cure Hybrid Method. Composites Part A, 39, 154-163.
[3]	Mohan, N.S., Kulkarni, S.M. and Ramach, A. (2007) Delamination Analysis in Drilling Process of Glass Fiber Reinforced Plastic (GFRP) Composite Materials. Journal of Materials Processing Technology, 186, 265-271.
[4]	Leong, Y.W., Yamaguchi, S., Mizoguchi, M., Hamada, H., Ishiaku, U.S. and Tsujii, T. (2004) The Effect of Molding Conditions on Mechanical and Morphological Properties at the Interface of Film Insert Injection Molded Polypropylene-Film/Polypropylene Matrix. Polymer Engineering and Science, 44, 2327-2334. https://doi.org/10.1002/pen.20260
[5]	Mao, W., Wyatt, T.P., Chen, J. and Wang, J. (2015) Insert Injection Molding of High-Density Polyethylene Single-Polymer Composites. Polymer Engineering and Science, 55, 2448-2456. https://doi.org/10.1002/pen.24132
[6]	Pinpathomrat, B., Mathurosemontri, S., Uawongsuwan, P., Thumsorn, S. and Hamada H. (2016) Study on Adhesive Property of Insert Injection Molded Glass Fiber Reinforced Polypropylene Composites. Energy Procedia, 89, 291-298.