Author(s)

Riichi Murayama

Faculty of Engineering, Fukuoka Institute of Technology, Fukuoka, Japan.

A guide wave is provided with the characteristic of long range propagation in the axis direction of a pipe, so it is possible to detect many defects over a large pipe area at once. At present, there is a technique to generate a guide wave using a piezoelectric element (PZT). However, the transverse wave-transducer using PZT needs to require a high viscosity couplant because the transverse wave cannot travel into typical liquid like water or oil. A guide wave inspection system that uses an electromagnetic ultrasonic transducer (EMAT) which does not require any couplant has then been developed to solve this trouble. First, a guide wave into a pipe, L, T and F-mode, can be transmitted and received by a polarized shear horizontal transverse wave propagating to the thickness direction when the vibration direction has been adjusted to the best direction. At next stage, the three EMATs for L, T and F-mode with different polarized vibration directions were piled up to improve the performance at the same position under the permanent magnet to inspect the pipe at the same condition. Next, the system with the EMATs can be confirmed to be able to detect three guide wave modes signal with enough intensity. Finally, the detection performance using the test pipes with any artificial defects has been done by the developed pipe inspection system, and any drilled holes and any notches can be detected. It is indicated that the developed system could be useful in real industrial field.

Guide Wave, Transverse Wave, EMAT, Nondestructive Inspection, Pipe

Murayama, R. (2016) A New Guide Wave Inspection System Using Three Polarized Transverse Wave EMATs without Any Couplant. Journal of Sensor Technology, 6, 110-121. doi: 10.4236/jst.2016.64009.