Surfactants are used for formulation metal working fluids. These fluids are applied to the interface between a cutting tool and the metal working piece to provide friction reduction. In the present paper, poly aromatic ammonium sulphonate and polyaromatic benzyl triethanolamsonium ethoxylate with 6 ethylene oxide units were synthesized and blended with coupling agent like dodecyl alcohol and oleic acid to produce cutting fluid and evaluate as antiwear. Values of surface tension of these additives were measured in oil phase and consequently CMC was determined for all additives and their mixtures in oil phase. The efficiency of these additives depends on their chemical structure and the presence of ether oxygen brings about the association of the surfactant with metal surface, hence very good wetting properties. The antiwear characteristic of surfactants increases with increasing polar linkages in the aromatic moieties forming chelated and coordinated layer. This is due to the increase in the number of sites to chemisorption on the metal surface. The films formed are highly condensed ring aromatic layered structures. These films provide lower wear and depend on the type of surfactants concentration and sliding speed. The surface of metal was analyzed by SEM/EDX techniques. These studies have led to much clear evidence of the intimate relationship between the chemical structure of the surfactants and their film forming. More confirmation for suggested mechanism was investigated by measuring the area occupied per molecule of the surfactant in oil phase. The results indicate that the sulphonate group is less efficient than ethoxylate group. At the same time, the micelle of surfactants acts as oil dispersant and improves adsorption of oil on the metal surface.